LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 4.4L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Camshaft Sensor
    GM1247907Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Inspect the camshaft position sensor O-ring for wear or damage. If a problem is found, replace the O-ring.
  1. Lubricate the camshaft position sensor O-ring with engine oil.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the right bank intake camshaft position sensor (2) and retaining bolt.

    Tighten:  Tighten the camshaft position sensor retaining bolt to 10 N.m (89 lb in).

  3. Connect the camshaft position sensor electrical connector.
  4. Operate the engine and inspect the camshaft position sensor for engine oil leaks.
  5. Install the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
scientia non olet · About LEMON Manuals