LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 4.4L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Left Exhaust Camshaft Position Actuator Solenoid
    GM1239401Courtesy of GENERAL MOTORS CORP.
  1. Remove the remote power steering reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement (LH2) or Remote Power Steering Fluid Reservoir Replacement (LY7) .
  2. Remove the air conditioning, power steering and water pump drive belt tensioner. Refer to Drive Belt Tensioner Replacement - Air Conditioning, Power Steering, and Water Pump .
  3. Disconnect the actuator solenoid electrical connector.
  4. Remove the left exhaust camshaft position (CMP) actuator solenoid bolts.
  5. Remove the left exhaust CMP actuator solenoid.
scientia non olet · About LEMON Manuals