LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 4.4L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Camshaft Position Actuator Magnet & Bolts
    GM1254509Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
  2. Disconnect the actuator solenoid electrical connector.
  3. Remove the right exhaust camshaft position (CMP) actuator solenoid bolts.
  4. Remove the right exhaust CMP actuator solenoid.
scientia non olet · About LEMON Manuals