LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 4.4L - Introduction (2 Of 2)) >> Repair Instructions >> Barometric Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: BARO, MAP & SCIAP Sensors
    GM1613998Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Remove the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
  3. Disconnect the barometric pressure (BARO) sensor (2) electrical connector.
    4. IMPORTANT: The BARO sensor does not use a vacuum line.
  4. Remove the BARO sensor (2) from the bracket.
scientia non olet · About LEMON Manuals