Daytime Running Lamps (DRL) Inoperative (Norway/Sweden)

Step	Action	Yes	No
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Do the low beam headlamps operate properly?	Go to Step 3	Go to Headlamps Inoperative - Low Beams (Standard Headlamps) or Headlamps Inoperative - Low Beams (HID Headlamps)
3	Verify that the park brake is not APPLIED. Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, observe the Parking Brake Switch parameter in the instrument panel module (IPM) inputs list. Does the scan tool display RELEASED?	Go to Step 4	Go to Symptoms - Hydraulic Brakes
4	Turn OFF the ignition. Remove the headlamp low beam relay located in the underhood fuse block. Install a test lamp between the headlamp low beam relay battery voltage circuit terminal and the headlamp low beam relay control circuit terminal. Refer to Circuit Testing . Turn ON the ignition, with the engine OFF. Operate the DRL system. Does the test lamp illuminate?	Go to Step 6	Go to Step 5
5	Inspect for poor connections at the harness connector of the IPM. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 8	Go to Step 7
6	Replace the headlamp low beam relay. Refer to Relay Replacement (Within an Electrical Center) or Relay Replacement (Attached to Wire Harness) . Did you complete the replacement?	Go to Step 8	-
7	Replace the IPM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 8	-
8	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2