Daytime Running Lamps (DRL) Inoperative (Domestic/Canadian)

Step	Action	Yes	No
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Do the turn signals operate properly?	Go to Step 3	Go to Turn Signal Lamps and/or Indicators Inoperative
3	Verify that the park brake is not APPLIED. Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, observe the Parking Brake Switch parameter in the instrument panel module (IPM) inputs list. Does the scan tool display RELEASED?	Go to Step 4	Go to Symptoms - Hydraulic Brakes
4	Verify that the automatic wiper system is OFF. Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, observe the Lights On With Wipers parameter in the instrument panel module (IPM) inputs list. Does the scan tool display OFF?	Go to Step 5	Go to Symptoms - Wiper/Washer Systems
5	Inspect for poor connections at the harness connector of the IPM. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 7	Go to Step 6
6	Replace the IPM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 7	-
7	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2