LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Transfer Case - Overhaul - BW 4476/79) >> Repair Instructions >> Cleaning and Inspection >> Front Output Shaft

Front Output Shaft

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Front Output Shaft Components
    GM928047Courtesy of GENERAL MOTORS CORP.
  1. Clean the front output shaft (112) in cleaning solvent and air dry.
  2. Inspect for spun bearings at the front output shaft bearing areas.
  3. Inspect the front output internal splines and driven gear splines for damage or excessive wear.
  4. Replace the front output shaft if it is damaged.
  5. Inspect the front output shaft bearings (113 and 116) for the following conditions:
    • Scoring
    • Pitting
    • Brinelling
    • Excessive wear
  6. Replace the front output shaft bearings if they are faulty. Refer to Transfer Case Disassemble  and Transfer Case Assemble .
scientia non olet · About LEMON Manuals