Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the following subassemblies:
- The right exhaust manifold
Refer to Exhaust Manifold Replacement - Right (LY7) or Exhaust Manifold Replacement - Right (LH2) in Engine Exhaust.
- The water crossover
Refer to Water Outlet Housing Replacement (LH2) or Water Outlet Housing Replacement (LY7) in Engine Cooling.
- The intake manifold
Refer to Intake Manifold Replacement .
- The right secondary camshaft drive chain
Refer to Secondary Camshaft Drive Chain Replacement - Right .
- The right camshaft
Refer to Camshaft Replacement - Right .
- The right exhaust manifold
- Remove the right cylinder head. Make sure that no dowel guide pins are stuck in the cylinder head. Refer to Cylinder Head Removal - Right .
- Disassemble the right cylinder head. Refer to Cylinder Head Disassemble .
- Clean and inspect the cylinder head. Refer to Cylinder Head Cleaning and Inspection .
- Assemble the right cylinder head. Refer to Cylinder Head Assemble .