Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the left cylinder head. Refer to Cylinder Head Installation - Left .
- Install the power steering reservoir and return hose retaining bolts to the cylinder head.
Tighten: Tighten the power steering reservoir and return hose retaining bolts to 50 N.m (37 lb ft).
- Install the following subassemblies:
- The left camshafts - Refer to Camshaft Replacement - Left .
- The left secondary camshaft drive chain - Refer to Secondary Camshaft Drive Chain Replacement - Left .
- The intake manifold - Refer to Intake Manifold Replacement .
- The water crossover - Refer to Water Outlet Housing Replacement (LH2) or Water Outlet Housing Replacement (LY7) in Engine Cooling.
- The left exhaust manifold - Refer to Exhaust Manifold Replacement - Left (LY7) or Exhaust Manifold Replacement - Left (LH2) in Engine Exhaust.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.