Engine Oil Temperature Indicator Always On (5.7L)
Engine Oil Temperature Indicator Always On (5.7L)
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics Connector End View Reference: Engine Controls Connector End Views in Engine Controls - 5.7L |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Start the engine. Does the OIL TEMP HIGH message display in the radio? |
- | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
| 3 |
|
30°C-140°C (86°F-284°F) | Go to Step 10 | Go to Step 4 |
| 4 |
|
30°C (86°F) | Go to Step 6 | Go to Step 5 |
| 5 | Test the signal circuit of the engine oil temperature switch for a short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the engine oil temperature switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 8 |
| 7 | Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 9 |
| 8 | Replace the engine oil temperature switch. Refer to Engine Oil Level Sensor and/or Switch Replacement
in Engine Mechanical - 5.7L. Did you complete the replacement? |
- | Go to Step 11 | - |
| 9 | Replace the IPC. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 11 | - |
| 10 | Replace the radio. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 11 | - |
| 11 | Operate the system in order to verify the repair. Did you correct the condition? |
- | System OK | Go to Step 2 |