LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - M35) >> Repair Instructions >> Mainshaft Rear Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Output Shaft Seal
    GM801800Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the rubber sealing lip and the outside diameter of the output shaft seal with DEXTRON®-III
  2. Install the output shaft seal using J 45510 .
    3. Fig 2: Installing Drive Flange To Transmission Output Shaft
    GM801795Courtesy of GENERAL MOTORS CORP.
  3. Install the drive flange to the transmission output shaft.
    4. IMPORTANT: Use a new drive flange nut. Do NOT reuse the old nut.
  4. Apply gasket maker GM P/N 1052942 (Canadian P/N 10953466) to the sealing flange surface of the nut.
  5. Apply thread locker GM P/N 12345382 (Canadian P/N 10953489) to the threads of the nut.
    6. Fig 3: View Of Flange Tool
    GM804354Courtesy of GENERAL MOTORS CORP.
  6. Install J 45012  to the drive flange.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the new drive flange nut.

    Tighten the drive flange nut using the J 29873  while holding the J 45012  .

    Tighten:  Tighten the drive flange nut to 100 N.m (74 lb ft).

  8. Remove J 45012  from the drive flange.
    9. Fig 4: Installing Propeller Shaft Coupler To Transmission Flange
    GM803962Courtesy of GENERAL MOTORS CORP.
  9. Install the propeller shaft coupler (1) to the transmission flange. Refer to Propeller Shaft Replacement (Automatic Transmission) , Propeller Shaft Replacement (Manual Transmission) or Propeller Shaft Replacement (CTS-V) in Driveline/Axle.
  10. Check the transmission fluid level. Refer to Transmission Fluid Level Inspection .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals