LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Shift Control Linkage Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Shift Linkage
    GM785877Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control linkage to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the manual shift shaft nut.

    Tighten:  Tighten the manual shift shaft nut to 15 N.m (11 lb ft).

    3. Fig 2: Connecting Shift Control Linkage Rod
    GM785879Courtesy of GENERAL MOTORS CORP.
  3. Connect the shift control linkage rod to the shift control assembly.
  4. Install the nut to the shift control linkage rod.
  5. Adjust the shift control linkage. Refer to Shift Control Linkage Adjustment .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals