Shift Control Linkage Adjustment

WARNING: This page is about a different variant/trim than selected.

Position the shift lever in PARK.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

Fig 1: Loosening Shift Control Linkage Adjustment Nut

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Loosen the shift control linkage adjustment nut to allow the adjuster to slide freely.
Hold the selector lever on transmission against the rear stop to eliminate any play.
Tighten: Tighten the shift control linkage adjustment nut to 9 N.m (80 lb in).
Lower the vehicle.

Fig 2: Inspecting Operation Of Starting System With Shift Lever

Courtesy of GENERAL MOTORS CORP.

Inspect the operation of the starting system with the shift lever in each position. The engine should only crank when the lever is in the PARK or NEUTRAL position.