LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 5L40-E (Introduction, Service & Replacement)) >> Repair Instructions >> Floor Shift Control Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Shift Control Assembly
    GM796320Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control assembly to the tunnel reinforcement.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 4 nuts securing the shift control assembly to the tunnel reinforcement.

    Tighten:  Tighten the nuts to 12 N.m (106 lb in).

    3. Fig 2: Installing Electrical Connector To Shift Control Assembly
    GM796319Courtesy of GENERAL MOTORS CORP.
  3. Install the electrical connector (1) to the shift control assembly.
  4. Connect the shift lock actuator electrical connector (2) at the shift control assembly.
  5. Install the center console assembly. Refer to Console Replacement - Front Floor in Instrument Panel, Gages and Console.
  6. Install the shift control boot. Refer to Floor Shift Control Boot Replacement .
  7. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    8. Fig 3: Connecting Shift Control Linkage Rod To Shift Control Assembly
    GM785879Courtesy of GENERAL MOTORS CORP.
  8. Connect the shift control linkage rod to the shift control assembly.
  9. Install the shift control linkage adjustment nut finger tight.
  10. Adjust the shift control linkage. Refer to Shift Control Linkage Adjustment .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals