LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Oil Level Indicator and Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Level Indicator Tube
    GM902882Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the secondary (small square) heat shield is properly installed to the oil level indicator tube as noted during removal.
  1. Install the oil level indicator and tube. Refer to Oil Level Indicator and Tube Installation .
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Install the knock sensor. Refer to Knock Sensor (KS) Replacement - Bank 2 in Engine Controls - 3.6L (LY7).
  4. Install the heat shield clip to the oil level indicator tube as noted during removal.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals