Oil Level Indicator and Tube Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Removing & Installing Oil Level Indicator Tube O-Ring

Courtesy of GENERAL MOTORS CORP.

Fig 2: View Of Oil Level Indicator Tube

Courtesy of GENERAL MOTORS CORP.

Install the oil level indicator and tube by sliding the tube down through the lower crankcase hole.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the oil level indicator tube bracket bolt.
Tighten: Tighten the oil level indicator tube bracket bolt to 10 N.m (89 lb in).

Fig 3: Removing & Installing Left Exhaust Manifold Lower Insulator

Courtesy of GENERAL MOTORS CORP.

Install the left exhaust manifold lower insulator onto the oil level indicator tube.

Fig 4: Removing & Installing Left Exhaust Manifold Heat Shield

Courtesy of GENERAL MOTORS CORP.

Place the left exhaust manifold heat shield in position.
Install the exhaust manifold heat shield bolts.
Tighten: Tighten the exhaust manifold heat shield bolts to 10 N.m (89 lb in).

Fig 5: Removing & Installing Left Exhaust Manifold Upper Insulator

Courtesy of GENERAL MOTORS CORP.

Install the left exhaust manifold upper insulator onto the oil level indicator tube.