LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Crankshaft Balancer & Bolt
    GM902878Courtesy of GENERAL MOTORS CORP.
  1. Remove the A/C compressor and power steering pump drive belt. Refer to Drive Belt Tensioner Replacement - Generator and Water Pump .
  2. Remove the generator and water pump drive belt. Refer to Drive Belt Tensioner Replacement - Power Steering and Air Conditioning .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Use the J 24420-C  in order to remove the crankshaft balancer. Refer to Crankshaft Balancer Removal .
scientia non olet · About LEMON Manuals