LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Camshaft Cover Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install a NEW camshaft cover seal and NEW grommets.
    2. Fig 1: Removing & Installing Camshaft Cover
    GM902873Courtesy of GENERAL MOTORS CORP.
  2. Install the camshaft cover. Refer to Camshaft Cover Installation - Right .
    3. Fig 2: Ignition Coil View
    GM860797Courtesy of GENERAL MOTORS CORP.
  3. Install the ignition coils.
    4. Fig 3: View Of Right Camshaft Cover Wiring Harness Connector - Front
    GM945682Courtesy of GENERAL MOTORS CORP.
  4. Install the wiring harness to the front of the camshaft cover.
  5. Install the wiring harness conduit retainers to the wiring harness conduit.
    6. Fig 4: View Of Right Camshaft Cover Wiring Harness Connector - Top
    GM945536Courtesy of GENERAL MOTORS CORP.
  6. Install the wiring harness to the side of the camshaft cover.
    7. Fig 5: View Of Right Ignition Coils Electrical Connectors
    GM945711Courtesy of GENERAL MOTORS CORP.
  7. Connect the ignition coil electrical connectors.
  8. Install the upper intake manifold with the lower intake manifold. Refer to Intake Manifold Replacement - Lower .
  9. Install the engine cover. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals