LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Camshaft Cover Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install a NEW camshaft cover seal and NEW grommets.
    2. Fig 1: Removing & Installing Left Camshaft Cover
    GM902871Courtesy of GENERAL MOTORS CORP.
  2. Install the camshaft cover. Refer to Camshaft Cover Installation - Left .
    3. Fig 2: Identifying Left Cylinder Head Ignition Coils
    GM868186Courtesy of GENERAL MOTORS CORP.
  3. Install the ignition coils.
    4. Fig 3: View Of Left Camshaft Cover Wiring Harness Connector - Front
    GM945343Courtesy of GENERAL MOTORS CORP.
  4. Install the wiring harness to the front of the camshaft cover.
  5. Install the wiring harness conduit retainers to the wiring harness conduit.
    6. Fig 4: View Of Left Camshaft Cover Wiring Harness Connectors
    GM945337Courtesy of GENERAL MOTORS CORP.
  6. Install the wiring harness to the side of the camshaft cover.
    7. Fig 5: View Of Left Ignition Coils Wiring Harness Connectors
    GM945375Courtesy of GENERAL MOTORS CORP.
  7. Connect the ignition coil electrical connectors.
  8. Install the upper intake manifold with the lower intake manifold. Refer to Intake Manifold Replacement - Lower .
  9. Install the engine cover. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals