LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions >> Transmission Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Partially Installing Transmission
    GM1426234Courtesy of GENERAL MOTORS CORP.
  1. Partially install the transmission until the concentric slave cylinder bolts can be installed.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: Installing Concentric Slave Cylinder Bolts
    GM1426480Courtesy of GENERAL MOTORS CORP.
  2. Install the concentric slave cylinder bolts. Graphic shows transmission removed for clarity.

    Tighten:  Tighten the concentric slave cylinder bolts to 12 N.m (106 lb in).

  3. Install the transmission until flush with the clutch housing.
    4. Fig 3: Tightening Transmission To Clutch Housing Bolts
    GM1426979Courtesy of GENERAL MOTORS CORP.
  4. Tighten the transmission to the clutch housing bolts.

    Tighten:  Tighten the transmission to clutch housing bolts to 48 N.m (35 lb ft).

  5. Connect the following electrical connectors:
    • Transmission fluid temperature (TFT) sensor
    • Backup lamp switch
    • Vehicle speed sensor (VSS)
    • Reverse lockout solenoid
    • Gear select/skip shift solenoid
    6. Fig 4: Installing Shift Control Assembly
    GM1426990Courtesy of GENERAL MOTORS CORP.
  6. Install the shift control assembly to the transmission. Refer to Shift Control Assembly Replacement .
  7. Raise the transmission assembly.
    8. Fig 5: Installing Transmission Support
    GM785386Courtesy of GENERAL MOTORS CORP.
  8. Install the transmission support. Refer to Transmission Support Replacement in Frame and Underbody.
  9. Remove the transmission jack.
    10. Fig 6: View Of Propeller Shaft Nounting Components
    GM1236100Courtesy of GENERAL MOTORS CORP.
  10. Install the propeller shaft (6). Refer to Propeller Shaft Replacement (Automatic Transmission) , Propeller Shaft Replacement (Manual Transmission) or Propeller Shaft Replacement (CTS-V) in Propeller Shaft.
  11. Check the transmission fluid and fill as necessary. Refer to Transmission Fluid Level Inspection  and Transmission Fluid Replacement .
    12. Fig 7: View Of Exhaust System
    GM1215598Courtesy of GENERAL MOTORS CORP.
  12. Install the exhaust system. Refer to Exhaust System Replacement (LA3, LY9) , Exhaust System Replacement (LY7) and Exhaust System Replacement (LS6) in Engine Exhaust.
  13. Lower the vehicle.
    14. Fig 8: Installing Bolts Securing Shift Control Assembly To Adapter Plate
    GM834521Courtesy of GENERAL MOTORS CORP.
  14. Install the bolts (2) securing the shift control assembly to the adapter plate.

    Tighten:  Tighten the shift control bolts to 18 N.m (13 lb ft).

    15. Fig 9: Installing Sound Insulator Foam Block Into Console
    GM834525Courtesy of GENERAL MOTORS CORP.
  15. Install the sound insulator foam block into the console.
    16. Fig 10: Installing Shift Control Knob
    GM801327Courtesy of GENERAL MOTORS CORP.
  16. Install the shift control knob. Refer to Shift Control Knob Replacement .
scientia non olet · About LEMON Manuals