Transmission Fluid Level Inspection
WARNING: This page is about a different variant/trim than selected.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Clean any dirt from around the fill plug.
- Remove the transmission fill plug from the transmission.
- Check that the transmission fluid level is even with the bottom of the fill plug hole.
- Add Dexron-III transmission fluid, if necessary.
- Install the transmission fill plug to the transmission.
Tighten: Tighten the transmission fill plug to 18 N.m (13 lb ft).
- Lower the vehicle.
NOTE:
Refer to Fastener Notice in Cautions and Notices.