Engine Oil Pressure Indicator Always On
Engine Oil Pressure Indicator Always On
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics Connector End View Reference: Engine Control Module (ECM) Connector End Views or to Inline Harness Connector End Views |
|||
| 1 | Did you perform the Instrument Cluster Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Instrument Cluster |
| 2 | Start the engine. Does the engine oil pressure indicator illuminate after the displays test? |
Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
| 3 |
|
Go to Step 10 | Go to Step 4 |
| 4 |
|
Go to Step 6 | Go to Step 5 |
| 5 | Test the engine oil pressure switch signal circuit for a short to ground. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the engine oil pressure switch. Refer to Testing for Intermittent Conditions and Poor Connections
and to Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 8 |
| 7 | Inspect for poor connections at the harness connector of the ECM. Refer to Testing for Intermittent Conditions and Poor Connections
and to Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 9 |
| 8 | Replace the engine oil pressure switch. Refer to Engine Oil Pressure Sensor and/or Switch Replacement
in Engine Mechanical. Did you complete the replacement? |
Go to Step 11 | - |
| 9 |
IMPORTANT:
Program the replacement ECM. Replace the ECM. Refer to Engine Control Module (ECM) Replacement
in Engine Controls.Did you complete the replacement? |
Go to Step 11 | - |
| 10 | Replace the IPC. Refer to Instrument Panel Cluster (IPC) Replacement . Did you complete the replacement? |
Go to Step 11 | - |
| 11 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |