Change Engine Oil Indicator Always On

Step	Action	Values	Yes	No
Schematic Reference: Instrument Cluster Schematics
1	Did you perform the Diagnostic System Check - Instrument Cluster?	-	Go to Step 2	Go to Diagnostic System Check - Instrument Cluster
2	Start the engine. Does the CHANGE ENGINE OIL message illuminate in the Radio?	-	Go to Step 3	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3	Install a scan tool. With a scan tool, observe the Engine Oil Life parameter in the engine control module (ECM) instrument panel cluster (IPC) Data list. Does the Engine Oil Life parameter display 0%?	-	Go to Step 4	Go to Step 5
4	Reset the engine oil life. Refer to GM Oil Life System - Resetting in Maintenance and Lubrication. Does the CHANGE ENGINE OIL message turn off?	-	Go to Step 6	Go to Step 5
5	Replace the radio. Refer to Radio Replacement in Entertainment. Did you complete the replacement?	-	Go to Step 6	-
6	Operate the system in order to verify the repair. Did you correct the condition?	-	System OK	Go to Step 2