Installation Procedure

Install the I/P assembly (3) to the vehicle.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the I/P assembly to hinge pillar bolts (2).
Tighten

Tighten the I/P carrier bolts (2) to 25 N.m (18 lb ft).

Fig 1: Installing I/P Assembly To Hinge Pillar Bolts
Courtesy of GENERAL MOTORS CORP.
Install the I/P carrier to cowl nuts (1).
Tighten

Tighten the I/P carrier to cow nuts (1) to 25 N.m (18 lb ft).

Fig 2: Installing I/P Carrier To Cowl Nuts
Courtesy of GENERAL MOTORS CORP.
Install the I/P extension bolts (1).
Tighten

Tighten the I/P extension bolts (1) to 25 N.m (18 lb ft).

Fig 3: Installing I/P Extension Bolts
Courtesy of GENERAL MOTORS CORP.
Install the steering column support bolts (1). Refer to STEERING COLUMN REPLACEMENT in Steering Wheel and Column.
Install the steering shaft to the steering column. Refer to INTERMEDIATE STEERING SHAFT REPLACEMENT in Steering Wheel and Column.

Fig 4: Installing Steering Column Support Bolts
Courtesy of GENERAL MOTORS CORP.
Remove the J 42640 from the steering column.

Fig 5: Removing J 42640 From Steering Column
Courtesy of GENERAL MOTORS CORP.
Connect the steering column main harness electrical connector (1).

Fig 6: Connecting Steering Column Main Harness Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Connect the tilt and telescoping module electrical connector (1), if equipped.

Fig 7: Connecting Tilt & Telescoping Module Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Connect the body harness electrical connector (1) and the audio antenna connection (2).

Fig 8: Connecting Body Harness Electrical Connector & Audio Antenna Connection
Courtesy of GENERAL MOTORS CORP.
For RHD, Install the park brake cable to the park brake pedal assembly. Refer to PARK BRAKE CABLES in Disc.

Fig 9: Installing Park Brake Cable To Park Brake Pedal Assembly
Courtesy of GENERAL MOTORS CORP.
Connect the I/P to body electrical connectors (1) at top outside corners of I/P.

Fig 10: Connecting I/P To Body Electrical Connectors
Courtesy of GENERAL MOTORS CORP.
Install the defroster grille. Refer to DEFROSTER GRILLE REPLACEMENT .
Install the I/P upper trim pad. Refer to TRIM PAD REPLACEMENT - INSTRUMENT PANEL (I/P) UPPER .
Install the drivers knee bolster bracket. Refer to KNEE BOLSTER REPLACEMENT .
Install the floor console. Refer to CONSOLE REPLACEMENT (W/O UV8) or CONSOLE REPLACEMENT (W/ UV8) .
Install the left and right I/P outer trim cover. Refer to INSTRUMENT PANEL (I/P) OUTER TRIM COVER REPLACEMENT .
Enable the SIR. Refer to ZONE 3 and ZONE 5 in Air Bag Restraint Systems.