LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2003 >> Seville STS >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Ignition Switch Replacement (RHD) >> Installation Procedure

Installation Procedure

  1. Install the ignition switch (2) to the I/P retainer.
    NOTE: Refer to FASTENER NOTICE  in Cautions and Notices.
  2. Through the opening next to the steering column, install the ignition switch fastener (1).

    Tighten 

    Tighten the fastener to 2 N.m (18 lb in).

    Fig 1: Locating Ignition Switch Fastener (RHD)
    G02179101Courtesy of GENERAL MOTORS CORP.
  3. Through the I/P outer trim panel opening, install the ignition switch fasteners (1, 4).

    Tighten 

    Tighten the fastener to 2 N.m (18 lb in).

    Fig 2: Installing Ignition Switch Fasteners (RHD)
    G02179102Courtesy of GENERAL MOTORS CORP.
  4. Install the park lock cable (1) to the ignition switch.
    Fig 3: Installing Park Lock Cable To Ignition Switch (RHD)
    G02179103Courtesy of GENERAL MOTORS CORP.
  5. Connect the ignition switch electrical connectors.
  6. Install the lamp socket to the ignition switch.
  7. With the key installed in the ignition lock cylinder (1) insert the ignition lock cylinder (1) into the I/P opening (2).
    Fig 4: Inserting Ignition Lock Cylinder Into Instrument Panel Opening (RHD)
    G02179104Courtesy of GENERAL MOTORS CORP.
  8. The lock cylinder retaining tab (3) will produce an audible click, when fully engaged.
  9. Using light force, pull on the lock cylinder in order to ensure the lock cylinder is engaged.
  10. Turn the ignition to LOCK, then remove the key.
  11. Install the right I/P outer trim panel. Refer to INSTRUMENT PANEL (I/P) OUTER TRIM COVER REPLACEMENT   . 
  12. Install the knee bolster. Refer to KNEE BOLSTER REPLACEMENT   . 
  13. Enable the SIR system. Refer to ZONE 9 in Air Bag Restraint Systems.
  14. Connect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE in Battery.
  15. Inspect the ignition switch for proper operation in all positions.
  16. Release the park brake.
scientia non olet · About LEMON Manuals