LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2003 >> Seville STS >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Console Replacement (w/ UV8) >> Installation Procedure

Installation Procedure

NOTE: When removing or installing the center console, do not allow the metal brackets to scrape the seats and damage the material.
  1. Partially install the floor console.
  2. Lift up the rear of the floor console to access the cellular phone connections.
  3. Connect the cellular phone electrical connector (1).
  4. Connect the cellular phone coaxial cable (2).
    Fig 1: Connecting Cellular Phone Electrical Connector (w/UV8)
    G02179284Courtesy of GENERAL MOTORS CORP.
  5. Connect the floor console electrical connectors.
  6. Lift up on the rear of the floor console (1) and slide the console forward in order to align the front edges of the floor console with the lower I/P.

    Place the rear of the floor console onto the rear studs.

    NOTE: Refer to FASTENER NOTICE  in Cautions and Notices.
  7. Install the screws (2) through the floor console (1) to lower I/P.

    Tighten 

    Tighten the screws (2) to 2 N.m (18 lb in).

    Fig 2: Installing Console To Lower Instrument Panel Fasteners (w/UV8)
    G02179285Courtesy of GENERAL MOTORS CORP.
  8. Install the nuts (2) to the studs.

    Tighten 

    Tighten the nuts (2) to 10 N.m (89 lb in).

  9. Install the bolts (1).

    Tighten 

    Tighten the bolts (1) to 10 N.m (89 lb in).

    Fig 3: Installing Metal Bracket Arms Fasteners (w/UV8)
    G02179286Courtesy of GENERAL MOTORS CORP.
  10. Connect the electrical connectors (1, 2 ,3) on both sides of the console.
    Fig 4: Connecting Console Electrical Connectors
    G02179287Courtesy of GENERAL MOTORS CORP.
  11. Install the cover (1) to the floor of the storage bin.
  12. Install the park lock cable to the shifter. Refer to PARK LOCK CABLE REPLACEMENT (LHD)  or PARK LOCK CABLE REPLACEMENT (RHD)  in Automatic Transmission-4T80-E.
  13. Install the shift cable. Refer to AUTOMATIC TRANSMISSION RANGE SELECTOR CABLE REPLACEMENT  in Automatic Transmission-4T80-E.
  14. Install the left console trim panel. Refer to CONSOLE TRIM PANEL REPLACEMENT - LEFT   . 
  15. Install the right console trim panel. Refer to CONSOLE TRIM PANEL REPLACEMENT - RIGHT   . 
  16. Install the console trim plate. Refer to TRIM PLATE REPLACEMENT - CONSOLE   . 
  17. Install the storage bins or the CD changer as needed. Refer to CONSOLE STORAGE BIN REPLACEMENT   or REMOTE CD CHANGER REPLACEMENT  in Entertainment.
    Fig 5: Installing Floor Storage Bin Cover (w/UV8)
    G02179288Courtesy of GENERAL MOTORS CORP.
  18. Enable the SIR. Refer to ZONE 7 and ZONE 9 in Air Bag Restraint Systems.
scientia non olet · About LEMON Manuals