Installation Procedure

Important:  The electrical contact on the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.

1. Install the turn signal and multifunction switch assembly.
   NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
2. Secure by using 2 pan head tapping screws.

   Tighten 

   • Tighten the screw on the top of the column to 3 N.m (27 lb in).
   • Tighten the screw in the front to 7 N.m (62 lb in).
3. Connect the connectors to the turn signal and multifunction switch assembly.
4. Install the upper and lower trim covers. Refer to STEERING COLUMN TRIM COVERS REPLACEMENT .
5. Enable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling ZONE 3 in SIR.
   Fig 1: Turn Signal And Multifunction Switch Assembly

   Courtesy of GENERAL MOTORS CORP.