Installation Procedure
- Align the ignition lock cylinder case assembly (1) with the steering column tilt head assembly.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Secure the ignition lock cylinder case assembly (1) to the steering column using 3 pan head tapping screws (2).
Tighten
Tighten the screws to 7 N.m (62 lb in).
- Install the ignition switch assembly. Refer to IGNITION SWITCH REPLACEMENT .
- Install the ignition lock cylinder. Refer to IGNITION LOCK CYLINDER REPLACEMENT .
- Install the theft deterrent control module. Refer to THEFT DETERRENT CONTROL MODULE REPLACEMENT in Theft Deterrent.
- Install the turn signal cancel cam and upper bearing. Refer to TURN SIGNAL CANCEL CAM AND UPPER BEARING INNER RACE REPLACEMENT .
- Enable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling ZONE 3 in SIR.