Steering Shaft, Lower Bearing, and Jacket - Assemble - Off Vehicle (Floor Shift Standard)
- Attach the steering column support assembly (2) to the steering column jacket assembly (3) with 4 new TORX® head screws (1).
Tighten: Tighten the screws to 17 N.m (13 lb ft).
- Install the steering shaft assembly (1) into the steering column support assembly (2) and the steering column jacket assembly (3).
- Install the adapter and bearing assembly (1) onto the steering column jacket assembly.
- Align the tab on the adapter and bearing assembly (1) with the slot in the steering column jacket assembly.
- Push the adapter and bearing assembly (1) onto the steering shaft assembly until the tab snaps into the slot.
- Install the turn signal and multifunction switch assembly. Refer to Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle .
- Install the electronic lock module assembly. Refer to Electronic Column Lock Module - Assemble - Off Vehicle .
- Install the steering column into the vehicle. Refer to Steering Column Replacement .
- Install the steering wheel onto the steering column. Refer to Steering Wheel Replacement .
- Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM in SIR.
Fig 1: View Of TORX(R) Head Screws, Steering Column Support Assembly & Steering Column Jacket Assembly
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.
Fig 2: View Of Steering Shaft Assembly, Steering Column Support Assembly & Steering Column Jacket Assembly