Audio Too Loud with Rear Seat Audio (RSA) On

Step	Action	Yes	No
Schematic Reference: Radio/Audio System Schematics
1	Did you review the Radio/Audio System Description and Operation and perform the necessary inspections?	Go to Step 2	Go to Radio/Audio System Description and Operation
2	Turn ON the ignition, with the engine OFF. Turn ON the radio. Turn On the RSA Does the radio operate normally?	Go to TESTING FOR INTERMITTENT AND POOR CONNECTIONS	Go to Step 3
3	Turn OFF the ignition. Disconnect the radio. Test the Remote Radio Control Signal of the radio for an open. Refer to CIRCUIT TESTING andWIRING REPAIRS . Did you find and correct the condition?	Go to Step 6	Go to Step 4
4	Inspect for poor connections at the harness connectors of the radio and RSA controller. Refer to TESTING FOR INTERMITTENT AND POOR CONNECTIONS and CONNECTOR REPAIRS . Did you find and correct the condition?	Go to Step 6	Go to Step 5
5	Replace the RSA controller. Refer to Audio Control Replacement - Rear Seat . Did you complete the replacement?	Go to Step 6	-
6	Operate the system in order to verify the repair. Did you complete the repair?	System OK	Go to Step 2