Removal Procedure
CAUTION:
Refer to SIR CAUTION
.
- Disable the SIR. Refer to DISABLING SYSTEM .
- Disconnect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE .
- Remove the IP center storage compartment or the floor console. Refer to Compartment Replacement - IP (Base and DHS) or Compartment Replacement - IP (DTS) or Console Replacement - Front Floor (DTS, w/o UV8) or Console Replacement - Front Floor (DTS with UV8) .
- Remove the left IP outer trim cover. Refer to Instrument Panel (IP) Outer Trim Cover Replacement - Left .
- Remove the right IP outer trim cover. Refer to Instrument Panel (IP) Outer Trim Cover Replacement - Right .
- Remove the headlamp switch. Refer to HEADLAMP SWITCH REPLACEMENT .
- Remove the drivers knee bolster bracket. Refer to Knee Bolster Bracket Replacement - Left .
- Remove the radio or the navigation display module. Refer to RADIO REPLACEMENT (U1R, UM5, UM9) or RADIO REPLACEMENT (U3Q, U3R, U3S) .
- Remove the HVAC control module. Refer to HVAC CONTROL MODULE .
- Remove the IP cluster. Refer to Instrument Panel Cluster (IPC) Replacement .
- Remove the IP storage compartment. Refer to Storage Compartment Replacement - IP .
- Remove the right IP accessory trim plate. Refer Trim Plate Replacement - IP Accessory Right .
- Remove the IP fasteners (1) from each end of the IP retainer.
- Remove the remaining fasteners from the IP retainer (1).
- Partially remove the IP retainer (1) from the IP carrier (2). Disconnect the inside air temperature sensor electrical connector.
- Guide the wiring through the IP retainer openings as necessary.
- Remove the IP retainer (1) from the vehicle.
- Remove the Inside air temperature sensor from the IP retainer (1). Refer to REMOVAL & INSTALLATION (INSIDE ASSEMBLY) .