Removal Procedure
CAUTION:
Refer to SIR CAUTION
.
- Disable SIR. Refer to DISABLING SYSTEM .
- Remove the left knee bolster. Refer to Knee Bolster Replacement - Left (Without UV2) or Knee Bolster Replacement - Left (UV2) .
- Remove the left knee bolster support. Refer to Knee Bolster Bracket Replacement - Left .
- Remove the right knee bolster. Refer to Knee Bolster Replacement - Right .
- Remove the IP center seat or the floor console. Refer to Compartment Replacement - IP (Base and DHS) or Compartment Replacement - IP (DTS) or Console Replacement - Front Floor (DTS, w/o UV8) or Console Replacement - Front Floor (DTS with UV8) .
- Remove the IP outer trim panels. Refer to Instrument Panel (IP) Outer Trim Cover Replacement - Right and Instrument Panel (IP) Outer Trim Cover Replacement - Left .
- Remove the windshield pillar trim. Refer to GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR .
- Remove the defroster grille. Refer to Defroster Grille Replacement (Without UV2) or Defroster Grille Replacement (UV2) .
- Remove the IP upper trim pad. Refer to Trim Pad Replacement - IP Upper .
- Remove the heads up display, if equipped with UV8. Refer to Head Up Display Module Replacement .
- Disconnect the body to IP electrical connectors (1) at the top, outside corners of IP.
- Disconnect all other electrical connectors from the IP to body.
- Disconnect the steering column shaft from the steering column.
- Remove the steering column to body fasteners (1).
- For a DeVille base model, or the DeVille DHS, disconnect the shift cable from the steering column.
- Disconnect the Steering column to body connectors.
- Remove the IP center support bracket fasteners (1) to floor bracket.
- Remove IP carrier (1) to cowl fasteners.
- Remove the fasteners (1,2) from the left and right IP carrier to hinge pillar.
- Remove the IP and carrier assembly from the vehicle.