LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 1998 >> Seville STS >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Suspension - Electronic CV Road-Sensing >> Diagnostic Tests >> Code C1658: CVRSS Control Module Calibration Fault

Code C1658: CVRSS Control Module Calibration Fault

  1. Perform CVRSS system check. See CVRSS SYSTEM CHECK  under DIAGNOSIS & TESTING. After performing CVRSS system check, go to next step.
  2. Install scan tool. Turn ignition on, with engine off. Calibrate NEW CVRSS control module. See CALIBRATING CVRSS CONTROL MODULE  under ADJUSTMENTS. Clear codes. Wait 30 seconds, and then display CVRSS codes. If Code C1658 is set, go to next step. If Code C1658 is not set, see NOTES ON INTERMITTENTS under DIAGNOSIS & TESTING.
  3. Calibrate NEW CVRSS control module. See CALIBRATING CVRSS CONTROL MODULE under ADJUSTMENTS. Clear codes. Wait 30 seconds, and then display CVRSS codes. If Code C1658 is set, go to next step. If Code C1658 is not set, see NOTES ON INTERMITTENTS  under DIAGNOSIS & TESTING.
  4. Turn ignition off. Replace CVRSS control module. Reinstall/reconnect all components/connectors. Install scan tool. Turn ignition on, with engine off. Calibrate NEW CVRSS control module. See CALIBRATING CVRSS CONTROL MODULE  under ADJUSTMENTS.
scientia non olet · About LEMON Manuals