Engine Mount Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Engine Mount

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement . Remove intake manifold cover. Refer to Intake Manifold Cover Replacement . Support the engine with engine lifter.
1	Engine Mount Nut CAUTION: Refer to Fastener Caution . Tighten 62 N.m (46 lb ft)
2	Engine Mount Bolt (Qty: 2) Tighten 62 N.m (46 lb ft)
3	Engine Mount Bracket Bolt (Qty: 3) CAUTION: Refer to Torque-to-Yield Fastener Caution . Procedure Install NEW bolts. DO NOT reuse the old bolts. Tighten First pass: 50 N.m (37 lb ft) Final pass: 60 - 75 degrees Special Tools EN-45059 Angle Meter For equivalent regional tools, refer to Special Tools .
4	Engine Mount