Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- The cam (1) and the groove in the oil pump driven gear must align. Rotate the oil pump driven gear to match cam (1) and the groove in the oil pump driven gear.
- Clean the sealing surfaces.
- Install the engine front cover (2) and a NEW gasket (3).
- Install the engine front cover bolts (1) and tighten the bolts to 28 N.m (21 lb ft).
- Install the engine mount bracket. Refer to Engine Mount Bracket Replacement .
- Remove the engine support fixture. Refer to Engine Support Fixture .
- Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
- Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
NOTE:
The cam (1) is only plugged into the recess.
CAUTION:
Refer to Fastener Caution .
NOTE:
Remind the longer water pump bolt.