LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Verano Premium, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.4L (Lea)) >> Repair Instructions - On Vehicle >> Cylinder Head Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the radiator surge tank inlet hose. Refer to Radiator Surge Tank Inlet Hose/Pipe Replacement .
  2. Remove the three-way catalytic converter. Refer to Three-Way Catalytic Converter Replacement (2.4L LEA) .
  3. Remove the exhaust camshaft. Refer to Exhaust Camshaft Replacement .
  4. Remove the intake camshaft. Refer to Intake Camshaft Replacement .
  5. Remove the intake manifold. Refer to Intake Manifold Replacement .
  6. Remove the exhaust manifold. Refer to Exhaust Manifold Replacement (2.4L LEA) .
  7. Remove the fuel injection fuel rail assembly. Refer to Fuel Injection Fuel Rail Assembly Replacement .
  8. Remove the hydraulic valve lash adjuster. Refer to Hydraulic Valve Lash Adjuster Replacement .
    9. Fig 1: Cylinder Head Bolt Loosening Sequence
    GM2557069Courtesy of GENERAL MOTORS COMPANY
  9. Loosen the cylinder head bolts in sequence as shown.
    10. Fig 2: Cylinder Head, Gasket & Bolts
    GM2557067Courtesy of GENERAL MOTORS COMPANY
  10. Remove and DISCARD the 14 cylinder head bolts (1) and (2).
  11. Remove the cylinder head (3) with the cylinder head gasket (4).
scientia non olet · About LEMON Manuals