LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Verano Leather >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LHU)) >> Repair Instructions - On Vehicle >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front compartment splash shield - right side. Refer to Front Compartment Splash Shield Replacement .
  3. Remove the front part of the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
    4. Fig 1: Drive Belt & Tensioner Hole
    GM2699392Courtesy of GENERAL MOTORS COMPANY
  4. Install the EN-6151-A  chuck key to the drive belt tensioner hole (2).
  5. Tension the drive belt tensioner counterclockwise and hold tension.
  6. Remove the drive belt (1).
  7. Release tension from the drive belt tensioner and allow the tensioner to slide back slowly.
scientia non olet · About LEMON Manuals