Water Pump Installation (LDK, LHU)
WARNING: This page is about a different variant/trim than selected.
NOTE:
Prior to installing the water pump, read the entire procedure. Pay special attention to avoid part damage and to ensure proper sealing.
- If necessary, install the water pump sprocket (2) and bolts (1).
- Tighten the bolts to 10 N.m (89 lb in).
- Install the water pump assembly (1) with a new gasket (2).
- Install the water pump bolts. Finger tighten the bolts.
- Tighten the water pump bolts to 25 N.m (18 lb ft).
- Apply sealant to the water pump drain plug. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Install the water pump drain plug and tighten to 20 N.m (15 lb ft), if necessary.
- Install the water feed tube (2).
- Lubricate the feed tube O-ring with antifreeze.
- Install the water feed tube by twisting and pushing toward the water pump. Take care not to tear or damage the O-ring.
- Install the thermostat housing (1) to block bolts and stud and tighten the thermostat housing bolts to 10 N.m (89 lb in).
- Install the coolant temperature sensor (1) by hand.
- Tighten the coolant temperature sensor to 20 N.m (15 lb ft).
CAUTION:
Refer to Fastener Caution .
NOTE:
Use a suitable size hex key as shown to hold the sprocket.
NOTE:
Do not install the front water pump bolt until after the engine front cover is on.