Engine Flywheel Installation (Manual Transmission)

Special Tools

• EN-43653  Flywheel Holding Tool
• EN-45059  Angle Meter

For equivalent regional tools, refer to Special Tools (LDK, LHU) .

Fig 1: Clutch Driven Plate
Courtesy of GENERAL MOTORS COMPANY
1. Install the clutch pilot bearing for manual transmission.
2. Install the flywheel (1).
3. Install the NEW bolts.
4. Install EN-43653  flywheel holding tool in the starter assembly location, engaging the flywheel, in order to prevent crankshaft rotation.
CAUTION:

Refer to Fastener Caution .

5. Tighten the flywheel bolts to 53 N.m (39 lb ft) plus 25 degreesusing the EN-45059  angle meter.
6. Install the clutch driven plate (2).
Fig 2: Clutch Pressure Plate And Bolts
Courtesy of GENERAL MOTORS COMPANY
7. Install the clutch pressure plate (1) and bolts.
8. Tighten the clutch pressure plate bolts to 24 N.m (18 lb ft).
9. Remove EN-43653  flywheel holding tool.