LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6T70 - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement (AWD) >> Installation Procedure

Installation Procedure

  1. Position the transaxle bracket to the transaxle.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the transfer case bracket bolts and tighten to 100 N.m (74 lb ft).
    3. Fig 1: Transaxle Mount Components
    GM2201655Courtesy of GENERAL MOTORS COMPANY
  3. Install the transaxle mount (2) to the frame.
  4. Install the longer transaxle mount to frame bolt (3,4) and tighten to 62 N.m (46 lb ft).
  5. Install the shorter transaxle mount to frame bolts and tighten to 100 N.m (74 lb ft).
  6. Install the through bolt (1) and tighten to 100 N.m (74 lb ft).
  7. Remove the support from the transaxle.
  8. Install the propeller shaft. Refer to Propeller Shaft Replacement
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals