Drive Support Seal Installation
Drive Support Seal Installation
| Callout | Component Name |
|---|---|
| 1 | Front Differential Transfer Drive Gear Support Seal
NOTE:
A NEW seal must be installed. Special Tools DT-46624 Support Seal Installer For equivalent regional tools, refer to Special Tools . |
| 2 | Small Chamfer Faces Up
CAUTION:
To avoid damaging the seal, first place DT466241 with the small chamfer end facing up and leave in place for at least 60 seconds. |
| 3 | Large Chamfer Faces Up
NOTE:
Turn DT46624-1 which is part of DT-46624 seal installer, over with the large chamfer end facing up for 60 seconds to ensure that the seal has been properly sized. |