Stabilizer Shaft Insulator Replacement (GNE)

Fig 1: Stabilizer Shaft Insulator (GNE)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation . Disconnect the stabilizer links from the stabilizer shaft. Refer to Stabilizer Shaft Link Replacement (GNE) .
1	Stabilizer Shaft Insulator Fastener (Qty:2) CAUTION: Refer to Fastener Caution . Procedure Install NEW bolts. Tighten 22 N.m (16 lb ft) + 30 degrees
2	Stabilizer Shaft Bracket Procedure Replace one insulator at a time to ensure the right position and angle.
3	Stabilizer Shaft Insulator