Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Disconnect the steering linkage outer tie rod (3) from the steering knuckle. Refer to Steering Linkage Outer Tie Rod Replacement .
- Disconnect the front wheel drive shaft (1) from the front wheel bearing and hub assembly. Refer to Front Wheel Drive Shaft Replacement - Left Side , or Front Wheel Drive Shaft Replacement - Right Side .
- Remove the front brake rotor (1) from the steering knuckle. Refer to Front Brake Rotor Replacement (J60, J61) Or Front Brake Rotor Replacement (J64) .
- If equipped, disconnect the electronic front suspension wiring harness (2) from the strut assembly.
- Remove the front wheel speed sensor (1) from the steering knuckle. Refer to Front Wheel Speed Sensor Replacement (Without F45) or Front Wheel Speed Sensor Replacement (With F45) .
- Disconnect the front lower control arm (2) from the steering knuckle. Refer to Lower Control Arm Replacement (GNB) .
- Support the front lower control arm with a jackstand.
- Disconnect the strut assembly (4) from the front suspension strut yoke. Refer to Strut Assembly Removal and Installation (GNB) .
- Remove the front suspension strut yoke (1) from the vehicle.
- Transfer components as necessary.