LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Manual Transaxle - F40) >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Seal Replacement - Right Side

Front Wheel Drive Shaft Seal Replacement - Right Side

WARNING: This page is about a different variant/trim than selected.
Fig 1: Front Wheel Drive Shaft Seal - Right Side
GM2019258Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
WARNING:

To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.

WARNING:

Refer to Safety Glasses Warning .

Preliminary Procedures

  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the intermediate shaft. Refer to Front Wheel Drive Shaft Replacement - Right Side .
  3. Place a drain pan underneath to collect transmission fluid.
1 Front Wheel Drive Shaft Seal

Procedure

  1. Remove drive axle shaft seal ring with DT-7004  hook and DT-586  hammer.
  2. Coat new axle shaft seal ring with transmission fluid.
  3. Install the drive axle shaft seal ring flush into transmission with DT-519  installer.
  4. Check transmission fluid level. Refer to Transmission Fluid Drain and Fill .

Special Tools

  • DT-519  Seal Installer
  • DT-586  Slide Hammer
  • DT-7004  Remover Hook

For equivalent regional tools, refer to Special Tools .