LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 6T40 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Transmission Mount To Transmission Bolts
    GM2199354Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Using the outline made by the spray paint or marker, install the transmission mount to transmission bolts (2) and tighten to 100 N.m (74 lb ft).
    2. Fig 2: Transaxle Brace & Bolt
    GM2199343Courtesy of GENERAL MOTORS COMPANY
  2. Install the transaxle brace (3) with bolt (2) seated in the brace.
  3. Install the transaxle brace bolt (1) and tighten to 50 N.m (37 lb ft).
  4. Tighten the brace bolt (2) to 100 N.m (74 lb ft).
    5. Fig 3: Rear Transmission Mount Through Bolt
    GM2199347Courtesy of GENERAL MOTORS COMPANY
  5. Install the transmission mount to bracket through bolt (1) and tighten to 100 N.m (74 lb ft).
    6. Fig 4: Rear Mount To Frame Fasteners
    GM2199358Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Use NEW bolts only.

  6. Install the rear mount to frame fasteners (1, 2) and tighten to 100 N.m (74 lb ft) plus 120-130degrees.
  7. Perform the Powertrain Mount Balancing - Lower procedure. Refer to Powertrain Mount Balancing - Lower .
  8. Remove the jack stand.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals