LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.0L (LTG) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Powertrain Mount Balancing - Lower

Powertrain Mount Balancing - Lower

    Fig 1: Front Transaxle Mount Through Bolt
    GM2813614Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Follow the balance procedure steps listed below. Powertrain mounts must be tightened in sequence.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Loosen the front transaxle mount through bolt (1).
  3. Loosen the rear transaxle mount through bolt.
  4. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
    5. CAUTION:

    Refer to Fastener Caution .

  5. Tighten the rear transaxle mount through bolt to 100 N.m (74 lb ft).
  6. Tighten the front transaxle mount through bolt (1) to 100 N.m (74 lb ft).
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals