Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Using the outline made by the spray paint or marker, install the left transmission mount (1).
- Install the transmission mount to frame rail bolts (2) and tighten to 22 N.m (16 lb ft).
- Using the engine support, raise the transmission until the transmission contacts the left transmission mount.
- Install the transmission mount to transmission bolts and tighten to 50 N.m (37 lb ft) plus 90-105 degrees.
- Install the wheel and tire assembly. Refer to Tire and Wheel Removal and Installation .
- Raise the vehicle.
- Install the rear transmission mount through bolt (1) and tighten to 105 N.m (77 lb ft).
- Install the front transmission mount through bolt (1) and tighten to 100 N.m (74 lb ft).
- Perform the Powertrain Mount Balancing - Lower. Refer to the appropriate engine section.
- Lower the vehicle.
- Remove the engine support fixture.
- Install the battery box. Refer to Battery Tray Replacement .
CAUTION:
Refer to Fastener Caution .