Auxiliary Fluid Pump Outlet Pipe Replacement (Hybrid)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Auxiliary Fluid Pump Outlet Pipe, Seals & Bolts

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the battery tray. Refer to Battery Tray Replacement .
1	A/Trans Auxiliary Fluid Pump Outlet Bolt (Qty:2) CAUTION: Refer to Fastener Caution . Tighten 22 N.m (16 lb ft)
2	Trans Auxiliary Fluid Pump Outlet Pipe Seal (Qty:2)
3	A/Trans Auxiliary Fluid Pump Outlet Pipe Procedure Fasten pipe to auxiliary pump and tighten bolt just enough to hold in place. Align pipe to case and tighten bolt just enough to hold in place. Check the transmission fluid level. Refer to Transmission Fluid Level and Condition Check .