LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.4L - Repair Instructions) >> Repair Instructions >> Camshaft Position Sensor Replacement - Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  2. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
    3. Fig 1: Locating Intake Camshaft Position (CMP) Sensor And Intake Camshaft Position (CMP) Sensor Connectors
    GM1815154Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the engine wiring harness electrical connector (1) from the intake camshaft position (CMP) sensor.
    4. Fig 2: Identifying CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS COMPANY
  4. Remove the intake CMP sensor bolt.
  5. Remove the intake CMP sensor.
scientia non olet · About LEMON Manuals