Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
NOTE:
Do Not perform this procedure unless directed here from the Fuel Injector Balance Test.
- Engine idling.
- Verify the scan tool Cylinder 1-4 Current Misfire Counter parameters do not increment.
- If the Cylinder 1-4 Current Misfire Counters increment
Refer to Circuit/System Testing.
- If the Cylinder 1-4 Current Misfire Counters do not increment
- If the Cylinder 1-4 Current Misfire Counters increment
- Verify the scan tool Cylinder 1-4 Injector Control Circuit Status parameters display OK.
- If the Cylinder 1-4 Injector Control Circuit Status parameters do not display OK
Refer to Circuit/System Testing.
- If the Cylinder 1-4 Injector Control Circuit Status parameters display OK
- If the Cylinder 1-4 Injector Control Circuit Status parameters do not display OK
- All OK.